- With these new plates you can install low voltage cables behind your flat panel TV or other audio/video devices, flush to the wall surface
- Allows cable management internally rather than externally.
- For professional installation.
- Allows Cable Management Internally Rather Than Externally
- For Professional Installation
Product Description
Use DataComm Electronics 1-gang recessed low voltage cable plates to install low voltage cables behind your flat panel TV, your amplifier or other audio/video devices…. More >>
{ 5 comments }
On dry wall installation you’ll need the ‘kit’ with the back mounting plate, that is because the screw spacing too small relative to the cut out in the wall.Suddenly price wise is no so attractive anymore.
I rate this 2 stars because lack of tech description, and personally I think that the sheet metal back plate ‘the kit’ is just an fix on a design flaw.
Rating: 2 / 5
This allowed me mount a TV on the wall without a “cord cover” running from the TV to the cabinet so it’s a very clean look. Be aware, you’ll probably need a wall that is open on the back side or be installing it as part of new construction for this device to be of much use to you. If you have finished construction, I’m not sure this would work for you because it would be difficult to anchor and nearly impossible to run the cables without an open wall to access the back of this device.
Rating: 4 / 5
There are a lot of options for running wires and this is one of the most economical and attractive ways, as the wires run directly to where they need to go!
Other wall plates use fittings which cost much more for the plate, and requires the purchase of additional cables- a cable through the wall to the back of the plate, and another from the front of the plate to the component.
There are many uses for this wall plate but in my case, I moved my cable modem and wireless router from my in-home office to the basement below. I ran just 2 wires to my office from below using this wall plate, the phone wire and the ethernet cable. The tower of wires and equipment are now gone from my office for an excellent space saving look.
The plate should probably cost $1 but this was the best price I could find and shipping was included. What is $5 anyways?
Recommended.
Rating: 5 / 5
I had searched all the local hardware stores for a wall plate to carry multiple wires and found nothing that pleased me. The Datacomm 45-0001-WH 1 did the job all with one plate and looks fantastic. I used it behind my wall mounted TV to funnel all the wires clean out of sight. I could not be more pleased. Thank You!
Rating: 5 / 5
Works great. One could easily run a HDMI, speaker wire and TV power cord through this. Exactly what I was looking for for a clean wall mounted HDTV installation.
Rating: 5 / 5
Comments on this entry are closed.